I got my tape unit installed using sam its a hp C1355A which HP says is a 4 GB unit when I used sam to back up all of my hard drives 2 one gig
seagates sam used three tapes up unill I aborted the backup I am using HPUX 10.20 the tape unit is setup as density dds2 ATT immedeiate mode exhaustive configure mode fixed block size
/dev/rmt/cot1d0wDDS2. the tapes are 3M 4mm dat tape DDS-90. They dont say DDS-2 is this the problem??





P.S. This thread has been moved from Disk to Tape Libraries and Drives. - Hp forum Moderator

HPUX Forever !