Results 1 to 2 of 2

Thread: RAIT Performance Issue

  1. #1

    Default RAIT Performance Issue

    Hi,

    I've been using Amanda 3.4.3 & LTO6 drive w/ Fibre channel for a few months. Since write speed of LTO6 drive (=160 MB/sec) is not high enough for us, Iím investigating into RAIT. Iím expecting that total 160 x 2 = 320MB/sec of write speed would be achievable when using #3 LTO6 drives.
    Iíve completed RAIT configuration with these #3 drives and found that simultaneous recording was successfully achieved. However, the problem is that write performance was worse than expected.
    I tried measuring write speed of each tape drive with ďiostat-scsi.stpĒ and it showed 84MB/sec a drive in average. This means that effective write speed was: 84 x 2 = 168 MB/sec - worse than expected 320 MB/sec.
    Since I thought that there was a bottleneck at HBA or holding disk, I tried the same test with using #2 drives and RAIT configuration. In this test, I found that each write speed was almost 160 MB/sec. This means that the system has a bandwidth of 320MB/sec from holding disk to tape, at least. According to this result, effective write speed in #3-drive configuration should have been: 320 x 2 / 3 = 213 MB/sec, at least.
    My configurations are as follows. I really appreciate any information or suggestion on this.

    ---Amanda.conf (excerpt)---
    inparallel 10 # maximum dumpers that will run in parallel
    dumporder "BTBTBTBTBTBT" # specify the priority order of each dumper
    taperalgo first # The algorithm used to choose which dump image to send
    runtapes 3 # number of tapes to be used in a single run of amdump
    tapedev "rait:{/dev/st0,/dev/st1,/dev/st2}"

    holdingdisk hd1 {
    comment "main holding disk"
    directory "/dumps/amanda" # where the holding disk is
    use -100 Mb # how much space can we use on it
    chunksize 3Gb # size of chunk if you want big dump to be
    }


    define tapetype LTO6x3 {
    comment "Created by amtapetype; compression enabled"
    length 7328456544 kbytes
    filemark 0 kbytes
    speed 510000 kps
    }


    define dumptype comp-user-tar {
    user-tar
    compress client fast
    priority high
    global
    program "GNUTAR"
    comment "root partitions dumped with tar"
    compress none
    index
    # exclude list "/etc/amanda/exclude.gtar"
    }

    --- HW configuration---
    #2 HBAs: One HBA has one port, the other has 2 ports, 8Gbps
    Holding Disk: RAM disk, DDR2. Mounted as tempfs
    #3 LTO6 Drives

    Thanks,
    Yuichi

  2. #2
    Join Date
    Nov 2005
    Location
    Canada
    Posts
    1,047

    Default

    Can you stop starting new thread with the exact same post.
    Read comments from our initial thread and add comments there.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •