December 16th, 2005, 01:15 PM
Automatic tape labelling
After not much ado, I am proud to have added automatic tape labeling to
Amanda. The enclosed patch adds a new configure option, label_new_tapes,
which when set will allow Amanda to pick up and use any tape without having
to label it. This patch also means you can avoid labeling your virtual tapes,
when dumping to disk.
I should point out that this behaviour is somewhat dangerous; thus, even if you apply the patch, you must enable the label_new_tapes config-file option to actually change anything. Most obviously, if you use your tapes for something other than Amanda, then Amanda will quite happily erase them with her own data. Furthermore, if you have a tape which is starting to fail, Amanda may decide it is a new tape, and overwrite it -- even if the data is still needed.
However, for installations where extremely high reliability is not required,
or for those using disk-based backup, or for those not using a tape changer,
automatic tape labelling is an excellent convenience.
Please comment on the patch; if there are no negative remarks, I'll plan to
merge it to 2.5.0 sometime in the next several days.
December 19th, 2005, 11:57 AM
Oops, forgot the patch.
April 9th, 2006, 10:19 PM
Hello Have u checked the label_new_tapes.patch.txt i don't think its a patch
Originally Posted by ian
April 13th, 2006, 09:49 PM
This patch is now part of Amanda 2.5 release. You download RPMs (including source and tar ball) from [url]http://www.zmanda.com/downloads.html[/url]
Are you looking for the patch for an older release? I don't think the patch is available for older releases.