Page 1 of 34 12311 ... LastLast
Threads 1 to 20 of 675

Forum: Amanda 2.6.x Installation, Configuration and Administration

Amanda 2.6.x questions, issues and success stories

  1. Sticky Thread Sticky: Amanda 2.6.1p1 released

    Started by paddy, April 10th, 2009 05:10 PM
    • Replies: 7
    • Views: 14,256
    June 14th, 2010, 09:52 PM Go to last post
  2. Sticky Thread Sticky: Release of amanda-2.6.0

    Started by martineau, April 1st, 2008 11:07 AM
    • Replies: 2
    • Views: 13,201
    August 27th, 2008, 11:21 AM Go to last post
  1. amcheck error with client same as host

    Started by lactroi, June 6th, 2017 05:03 AM
    • Replies: 0
    • Views: 1,184
    June 6th, 2017, 05:03 AM Go to last post
  2. Holding disk needed?

    Started by tuanhuylink, June 2nd, 2017 07:14 AM
    • Replies: 0
    • Views: 233
    June 2nd, 2017, 07:14 AM Go to last post
  3. slot issues

    Started by vladguan, April 20th, 2017 08:15 PM
    • Replies: 1
    • Views: 934
    April 20th, 2017, 08:36 PM Go to last post
  4. incrementing to the same tape

    Started by napata, May 30th, 2016 03:33 PM
    incremental, single tape drive, tape strategy
    • Replies: 0
    • Views: 6,960
    May 30th, 2016, 03:33 PM Go to last post
  5. Disaster Recovery Question

    Started by munkitkat, April 5th, 2016 02:39 AM
    • Replies: 0
    • Views: 3,165
    April 5th, 2016, 02:39 AM Go to last post
  6. backup restore changes permission

    Started by munkitkat, March 26th, 2016 05:23 AM
    • Replies: 0
    • Views: 2,818
    March 26th, 2016, 05:23 AM Go to last post
  7. Can't open tape device error - amcheck

    Started by markt, February 11th, 2016 09:22 AM
    • Replies: 2
    • Views: 3,461
    March 23rd, 2016, 05:03 AM Go to last post
  8. Backing up to a tape drive connected to a client

    Started by duongkhue84, January 19th, 2016 01:50 AM
    • Replies: 2
    • Views: 3,181
    January 19th, 2016, 06:03 AM Go to last post
  9. Long run time and insane compression ratio

    Started by DaleRobinson, December 9th, 2015 03:01 AM
    • Replies: 0
    • Views: 3,738
    December 9th, 2015, 03:01 AM Go to last post
  10. Changing gnutar_list_dir

    Started by jscarville, November 20th, 2015 06:48 AM
    amanda-client, conf, gnutar_list_dir, read only
    • Replies: 3
    • Views: 3,504
    November 21st, 2015, 06:41 AM Go to last post
  11. Exclamation bash: ammt: command not found

    Started by solarik, August 24th, 2015 01:24 PM
    ammt, no file, no program
    • Replies: 2
    • Views: 4,169
    August 25th, 2015, 04:41 AM Go to last post
  12. Clients must have user "amandabackup"?

    Started by Yzord, March 17th, 2015 05:49 AM
    • Replies: 3
    • Views: 4,439
    July 6th, 2015, 05:31 AM Go to last post
  13. The dumps did not finish properly!

    Started by Yzord, April 1st, 2015 05:41 AM
    • Replies: 2
    • Views: 3,777
    May 11th, 2015, 04:19 AM Go to last post
  14. Post Amanda Overwrite on the Tape

    Started by kamkis, April 6th, 2015 12:50 AM
    • Replies: 0
    • Views: 3,521
    April 6th, 2015, 12:50 AM Go to last post
  15. Clear VTapes

    Started by vladguan, September 28th, 2014 10:19 PM
    • Replies: 3
    • Views: 4,103
    March 26th, 2015, 05:35 AM Go to last post
  16. Problem about backups to vtape

    Started by macbookpro, January 29th, 2015 04:56 AM
    • Replies: 1
    • Views: 3,582
    March 18th, 2015, 04:30 AM Go to last post
  17. Information about Restore

    Started by macbookpro, January 29th, 2015 04:59 AM
    • Replies: 2
    • Views: 3,760
    March 4th, 2015, 01:49 AM Go to last post
  18. Question about ZMC & AMANDA

    Started by davidhan, September 25th, 2014 06:45 PM
    • Replies: 1
    • Views: 3,519
    February 28th, 2015, 12:37 AM Go to last post
    • Replies: 1
    • Views: 3,751
    February 20th, 2015, 03:11 AM Go to last post
    • Replies: 1
    • Views: 3,970
    February 15th, 2015, 08:25 PM Go to last post

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •