PDA

View Full Version : Problem: amrecover from S3



ckuenzel
June 9th, 2010, 08:49 AM
Hi Community,
this is my first post here, and i hope you can understand my bad english.

i Successfully set-up Zmanda 3.1.0 Server and Dumped some files to S3.

Now, when i try to recover the Files with amrecover i got a strange Error:


amanda@amandaclient:~/Desktop/Restore$ sudo amrecover test
AMRECOVER Version 3.1.0. Contacting server on amanda ...
220 amanda AMANDA index server (3.1.0) ready.
Setting restore date to today (2010-06-09)
200 Working date set to 2010-06-09.
200 Config set to test.
200 Dump host set to amandaclient.
Use the setdisk command to choose dump disk to recover
amrecover> setdisk /home/amanda/Desktop/Backupfiles
200 Disk set to /home/amanda/Desktop/Backupfiles.
amrecover> add CLEMI-TESTFILE.File
Added file /CLEMI-TESTFILE.File
amrecover> extract

Extracting files using tape drive chg-multi on host amanda.
The following tapes are needed: Test-0008

Extracting files using tape drive chg-multi on host amanda.
Load tape Test-0008 now
Continue [?/Y/n/s/d]? Y
Error setting 's3_secret_key' on device 'chg-multi'
Load tape Test-0008 nowContinue [?/Y/n/d]?

I Set the Keys (Access&Secret) in my Amanda.conf as Device-Property.
Is there an alternate Place to Set the Keys?

Greetings and thank you for your help

Clemens

dustin
June 9th, 2010, 12:30 PM
"using tape drive chg-multi" doesn't sound quite right. You should set amrecover_changer to "changer" in amanda.conf, and then set tapedev to "changer" in amanda-client.conf.

ckuenzel
June 18th, 2010, 10:51 AM
Hi Dustin,
thank you for your help.
i connected my system with success :)

Another Question, is it possible to recieve notification mails for amrecover such as amdump does?

billcarroll
January 3rd, 2011, 03:31 PM
I had a similar issue attempting to restore from a successful backup to Amazon S3. The error generally said unable to access s3, and listed disk file as the value it was trying to use for S3 -- "file://data/amanda/vtape/DailySet1"

At some point (probably messing with the 15 minute setup guide) I had set "tapedev "file://data/amanda/vtape/DailySet1" # your tape device" in amanda-client.conf.

I resolved the issue by commenting out the tapedev setting in the amanda-client.conf on every server so the clients would get the S3 info from the server.