PDA

View Full Version : Disabling debugging in Amanda



sakw
October 31st, 2006, 05:36 AM
First, I can't build amanda if I

./configure ... --without-debugging

I tracked it down to a missing macro in common-src/amanda.h and a missing declaration in restore-src/amidxtaped.c. The following patches below worked for me.

Second, it would be good if amanda was built with debugging compiled in, but run with debugging off (unless there was a problem). The doc'n for amanda.conf in http://wiki.zmanda.com/index.php/Amanda.conf (and the corresponding page for amanda-client.conf) describes several debug_XXX options that looked like they might do the trick, but, alas!, they don't work when I tried. Is this work-in-progress?

I suggest that there be some kind of master switch that turns debug on/off plus individual over-rides per module.

Thanks

--- common-src/amanda.h-debug 2006-10-31 13:35:45.000000000 +0000
+++ common-src/amanda.h 2006-10-31 13:35:58.000000000 +0000
@@ -428,6 +428,7 @@
#else /* }{ */
# define dbopen(a)
# define dbreopen(a,b)
+# define dbrename(a,b)
# define dbclose()
# define dbprintf(p)
# define dbfd() (-1)
--- restore-src/amidxtaped.c-debug 2006-10-31 13:36:56.000000000 +0000
+++ restore-src/amidxtaped.c 2006-10-31 13:37:44.000000000 +0000
@@ -245,6 +245,9 @@
char *conf_tapetype;
tapetype_t *tape;
char *line;
+#ifndef DEBUG_CODE
+ int i;
+#endif

safe_fd(DATA_FD_OFFSET, 4);
safe_cd();
---------

martineau
November 1st, 2006, 03:38 AM
Thanks for the patch.

But you should not use '--without-debugging', many error message are printed only in the debug file, if you don't have them, you will never be able to find the problem if amanda fail.
The 'debug_*' config option will be in amanda-2.5.2, and they will be use to control the level of debugging, not to completely remove them.